STUDIO OCEAN MARK OCEAN HOOKS REMOOVER

● We cope with treble and single hook by mode change (patent pending)

 

Turn mode / TURN MODE

Used when hook hooked out of the mouth when using single hook. 
When the trigger is pulled, the hook is rotated and the hook is released and can be easily pulled out.

 

 

 

 

 

 

 

 

 

 

 

Hold the HOLD MODE

firmly, and remove the hook by pushing, pulling, or twisting. 
In particular, when the lure has been swallowed, the hook on the far side can be removed with a certain hook that was impossible with a pliers.

 

 

 

(Example of use)

● Superior hook hold performance

The pliers’ pinching action is at two points of contact with the hooks, so the round hook with a cross section will cause slippage of the hook or damage to the shaft or assist part of the hook depending on the angle used no matter how strongly the hook is gripped To do. 
The hook remover holds the hook firmly with light force because it supports 3 points.

● Stainless steel gap

The stainless steel gap part is a strong design that won’t even catch a large single hooked hook. 

● T-shaped EVA handle stainless steel gaff

The T-shaped handle located at the rear end of the body is covered with an easy-grip EVA material. 
It is possible to rotate the griped handle without undue force.

● Durable design

It is made of highly durable stainless steel and aluminum alloy on the part where load is applied, and the sliding part is 
coated with the same high performance grease as the Blue Heaven series.

● 3 items that fit the target hook size

Treble hook 2/0 or more, single hook 5/0 or more

HR260L-HD

The hook position is so deep when large fish are scooped, and even with the reach of a long nose plier, the operating hand is exposed to the danger of the sharp hook. 
With a reach length of 260 mm that emphasizes safety rather than light operability, and considering long-term on-board use, the hook cover is made of stainless steel, and it is heavy with WPC treatment to prevent sticking to tides and fish grime. Duty specification. It is a limited model that you want to use for the captain of the big game.

HR180L

A well-reached reach length of 180 mm created by long-term field testing. 
Trigger to hold the hook securely, handle design to perform the operation of pushing, pulling, twisting while holding the hook. 
The gap section is a high-strength stainless steel, the hook cover is ultra-very duralumin, and other parts are also durable design that made the body of high-strength aluminum.

Treble hook 2/0 to 3, single hook 5/0 to 1/0, blue technique 23 · 20

HR150M

It is a light game special that puts the design concept of HR 180 in a compact body. 
In particular, it is most effective when using multi-point hooks in slow pitch jerks, and for small fish you can grab the leader and unhook it quickly in turn mode. 

※ When you move from the pliers you are used to for decades, you may be confused at first how to use. 
　However, once used, hook removal can be done safely and quickly. 
※ If you use an extremely small (thin) hook for the size of the main unit, it may cause malfunction such as the hook biting into the main unit. 
※ When removing the hook, pull the trigger firmly and make sure that the hook is fixed to the body. 
※ The act of removing the hook is very dangerous. Do not overestimate the use of the hook remover.